This is an old revision of the document!
Redistribution of 24 hour precipitation
RR_24 is the precipitation collected over the last 24 hours. The Qc1 check precipcollected_flag identifies if an RR_24 value is valid (fd=1), erroneous (fd=3) or is the accumulation (fd=2) of a number (N) of consecutive 24 hour periods, where N>1. For the case fd=2, the accumulated value shall be distributed over the N 24 hours periods.
For each day the calculated
RR_24= model_value*observed_accumulation/sum_of_model_values
where the model values for the N missing values of RR_24 are calculated by an interpolation from the other stations making measurements at the same time and for which fd=1. At present, the interpolation uses an inverse 2-D squared distance weighting. Other weighting and interpolation techniques might be added later.
The calculated RR_24 updates the corrected value in the kvalobs database.
Configuration and Parameters
The standard configuration options detailed in the user guide also apply to Redistribution.
Further configuration options are:
| Option | Default | Description |
|---|---|---|
| endpoint_cflags | fmis=4&fd=2 | specify the flags for accumulation endpoints. Endpoints not matching these flags will not be detected |
| endpoint_uflags | no constraints | |
| missingpoint_cflags | fmis=3&fd=2 | specify the flags for the missing points before the accumulation |
| missingpoint_uflags | no constraints | |
| neighbor_cflags | fd=1 | specify requirements for the neighbor stations used for the interpolations. Neighbor stations that do not match these flags will be ignored. |
| neighbor_uflags | U2=0 | |
| warn_and_stop_cflags | fhqc=)0( | define for which flags for the accumulation point or the missing points before the accumulation the only action should be to print a warning and stop |
| warn_and_stop_uflags | no constraints | |
| update_flagchange | fd=7;fmis=3->fmis=1;fmis=0->fmis=4 | flags to change for the accumulation endpoint and the missing points |
| ParamId | — | selects the parameter ids to use. The only value tested here is 110 (RR_24). |
| tids | — | accepted typeids |
| measurement_hour | 6 | specifies the hour at which the data are expected. Series containing data with other times will be rejected with a warning. |
| min_neighbors | 1 | specifies the minimum number of neighbor stations with good data |
| days_before_no_neighbor_warning | 28 | specifies the number of days after which a WARN is written to the logfile if there are not enough neighbor data |
Parameters
This algorithm has only been tested for paramid 110.